Specifying Functions With [Hex Selection] - Minolta Scanner Mode User Manual

Specifying Management Settings
2
Touch [Mode Selection], and
then use the keypad to type
in the mode number.
3
Touch [Bit Selection], and
then touch [←] and [→] to
move the cursor below the
bit to be changed.
4
Use the keypad to specify either "0" or "1" for the bit, and then touch
[Enter].
❍
To change other modes, repeat the procedure from step 2.
5
Continue touching [Enter] to return to the Utility screen, and then touch
[Exit] to return to the standby screen (initial screen).

Specifying functions with [HEX Selection]

1
Touch [Admin. 2], and then
touch [Soft SW Set].
❍
Refer to "Displaying the
Administrator
Management screen" on
page 13-11
Scanner Mode
13
13-45