Part Identification And Functions - Minolta PS7000 Operator's Manual

2-3

Part identification and functions

9
8
19
1. Scanner unit:
2. Lamp unit:
3. Control panel:
4. Shading plate:
5. Steel mirror:
6. Book table:
7. Table center:
8. Start key:
9. Power switch:
10. Printer connector:
1
2
3
4
5
10
11
6
7
18
20
The CCD sensor housed in this unit scans the original.
Illuminates the original when the scanner unit reads the
image.
Used to set the operating mode, and displays operating
status and error/warning messages.
Used to adjust the exposure.
Detects the position (height) of the original.
Place the original (book) face up on this table.
When a special binder or the like is used for the spine
(binding part) and the height of the original is 65 mm or
more, this center of the book table is pushed down to
lower the spine (binding part) of the original to a height
acceptable for scanning.
Press this key to start scanning the original.
Turns the Scanner on and off.
Connect the printer cable to this connector.
12
13 16
15
14
17