Table of Contents
Advertisement
LOADING THE UNIVERSAL HOLDER UH-P1
The universal holder UH-P1 is used with the following
attachments. Use the attachment suited to the film.
• 120/220 film attachment with glass (HA-P1), glassless
(HA-P2)
When scanning 120/220 (6x4.5, 6x6, 6x7, 6x8, 6x9) film
Select a film attachment with glass or a glassless film
attachment according to your purpose.
With glass:When the protection of the film or keeping a
plane quality is required.
Glassless: When you wish to avoid the effect caused by the
glass, for example, if you want to stay clear of
dust or dirt on the glass when scanning.
• Multi-format attachment (sold separately, HA-P3)
When scanning a TEM film, 35 mm panorama film, 16 mm
film, 4x4 or 24x24 film, etc.
120/220 (6x4.5, 6x6, 6x7, 6x8, 6x9) film attachment
with glass (HA-P1)
1. Install the selected attachment on
the holder.
Place the attachment with the button
side up at the position on the holder
that is suited for the attachment you
selected and fix it aligning with the two
grooves on the left side until it clicks.
If the 120/220 film attachment with
glassless (HA-P2) or the multi-format
attachment (HA-P3) is installed, remove
it beforehand.
2. Press the button on the
attachment to open the film
cover.
Before placing a film, remove the dust, etc. on the film,
holder, attachment or mask using a blower brush, etc.
3. Place the appropriate mask that is suited for the
5 size of the film.
Align the shape of attachment with that of mask, and fix
the two protruding parts on the upper side and the film
guide of the mask to the attachment and then fit the holes
on the pins of the attachment.
LOADING THE FILM HOLDER
Continued on the following page.
DiMAGE Scan Multi PRO
33
Advertisement
Table of Contents
