Specifying A Proxy - Minolta Scanner Mode User Manual

3

Specifying a proxy

<The following settings must be specified in order to connect to an FTP
server through a proxy server. These settings can only be specified with
PageScope Light.>
The following parameters can be set from the FTP Configuration page.
Parameter
IP Address
Port Number
FTP Connection
Timeout
1
Start up PageScope Light.
❍
Refer to "Using PageScope Light" on page 3-25.
2
Log into PageScope Light in Administrator mode.
3
Click [FTP Configuration] in the sub-menu that appeared after clicking
[FTP Server] in the menu on the [Network] tab.
4
Specify the necessary settings for the parameters in the page that
appeared.
5
Click the [Apply] button.
3-22
Description
Type in the IP address or host name for the proxy
server.
*The host name can only be typed in if the "DNS
Setting" parameter is set to "Yes".
Type in the port number of the proxy server.
Specify the amount of time until the connection
with the FTP server times out.
Preparation
Scanner Mode