Specifying Management Settings
13.12 Specifying Report Output Settings
The procedure for specifying report settings, which are set by the
administrator, is described below.
Report settings
• TX Report:
• Activity Report:
Specifying the setting for the "TX Report" parameter
1
Touch [Admin. 1], and then touch [Report Settings].
❍
Refer to "Displaying the Administrator Management screen" on
page 13-11.
2
Touch [TX Report].
Scanner Mode
Select how to output the report showing the
transmission result.
The factory setting is "Single destination : If TX
Fail, Multiple destination : If TX Fail".
Specify whether or not to automatically output
the activity report with every 50 communications.
The factory setting is "ON".
13
13-41