Using The Cycle Print Mode; Specifying The Interval Between Scanning Operations - Minolta MS6000 MK II User Manual

2-34

18. Using the Cycle Print Mode

This function automatically scans the next image following a preset period of time. Images
are manually loaded onto the Carrier Glass in between cycles.
This is a system setting that must be entered by an authorized dealer.
If you want to use the Cycle Print Mode, ask your Tech. Rep. to make the necessary system
setting. Then you can perform the following operations.
NOTE
This function is only available on the PR mode.

Specifying the interval between scanning operations

Press the Multi-Print Key to change the value to "A". This enables the Cycle Print
1
Mode. Press the Multi-Print Key to set the interval of time between scan operations.
(Refer to the diagram below).
Press the Memory Input key to store the currently selected interval setting of the Cycle
2
Print Mode into the memory.
Value 1
Period (sec.) 0.5
2 3 4
1.0 1.5 2.0
Memory Input Key
5 6 7
2.5 3.0 3.5
8 9 0
4.0 4.5 5.0