Step 3 Testing The Internet Fax - Fuji Xerox ApeosPort-V C3320 Administrator's Manual

10 Using the Internet Fax Service
When [POP3] is selected for [Protocol to Receive E-mail]
Configure the POP3 server.
For information on how to configure the POP3 server, refer to "POP3 Server Settings" (P.178).
For information on how to set the machine's e-mail address when you receive e-mails via POP3, refer to "Machine's E-mail
Address/Host Name" (P.175).
Important • When you enable POP over SSL in the POP3 Server Setting, receiving e-mail will be encrypted. POP
3) Select [Close].
5
Configure the server settings for sending e-mails.
Note
For information on how to configure the e-mail transmission, refer to "SMTP Server Settings" (P.179).
6
Configure the domain filtering for sending and receiving e-mails as necessary.
For information on how to configure the domain filtering, refer to "Domain Filtering" (P.190).
7
Set up the S/MIME information.
1) Select [Connectivity & Network Setup].
2) Select [Security Settings].
3) Select [S/MIME Settings], and then set the items.
For more information on how to configure S/MIME settings, refer to "S/MIME Settings" (P.186).
8
Select [Close] repeatedly until the [Tools] screen is displayed.
9
Select [Close].
Note
10
After the machine reboots, you can print a configuration report to confirm the settings of
each item.
For information on how to print a configuration report, refer to "Print Reports" (P.88).
10

Step 3 Testing the Internet Fax

Test the Internet fax transmission from the machine.
1
Select [Fax/Internet Fax] on the Services Home screen to display the [Fax/Internet Fax]
screen.
2
Select [Internet Fax] from the drop-down menu.
3
Enter a destination address.
4
Press the <Start> button to transmit.
5
Check whether the computer received the e-mail.
If the computer cannot receive the e-mail, refer to "Problem Solving" (P.383).
334
over SSL can be set using CentreWare Internet Services. For information on the setting procedure,
refer to "Configuring Machine Settings Using CentreWare Internet Services" (P.283).
• To send e-mails, SMTP server settings are required. When [POP3] is selected in [Protocol to Receive E-
mail], configure the SMTP server in [Outgoing/Incoming E-mail Settings].
• Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.