Step 3 Configuring Remote Authentication - Fuji Xerox ApeosPort-V C3320 Administrator's Manual

9 Scanner Environment Settings
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
3) Select [Tools] on the Services Home screen.
2
Enable the SMB port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SMB Client], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set the IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
address. If an IP address cannot be obtained automatically or manual configuration is
preferred, confirm the settings of an IP address, a subnet mask, and a gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.172).
9
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note
6
Print a configuration report to confirm that the SMB Client port is enabled and that TCP/IP
is set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.88).

Step 3 Configuring Remote Authentication

Set the Login Type to Login to Remote Accounts.
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
318
• You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.283).
• The default user ID is "11111".
• The default passcode is "x-admin".
• Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
• You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.283).