Protocol Settings; Ethernet Settings - Fuji Xerox ApeosPort-V C3320 Administrator's Manual

5 Tools
Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
Port Status
You can use the machine for print in the ThinPrint
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint.
Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any number s assigned to the other ports.
Note

Protocol Settings

Set the parameters required for communications. In [Protocol Settings], you can set the
5
following items.
Also on [Ping Connection Test], you can check whether or not the machine can be properly
connected to a network with the configured condition.

Ethernet Settings

Configure the Ethernet settings.
Ethernet - Rated Speed
Set the communication speed for the Ethernet interface.
Auto
Select this to detect the Ethernet transmission rate automatically.
100 Mbps Full-Duplex
Select this to set 100BASE-TX (Full Duplex) as the default value.
100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.
10 Mbps Full-Duplex
Select this to set 10BASE-T (Full Duplex) as the default value.
10 Mbps Half-Duplex
Select this to set 10BASE-T (Half Duplex) as the default value.
1000 Mbps
Select this to set 1000BASE-T as the default value.
Note
TCP/IP - Common Settings
Configure common settings to use TCP/IP.
172
• ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.
• 1000BASE-T is not available for some models. An optional component is required.
®
.print environment. The machine