Fuji Xerox ApeosPort-V C3320 Administrator's Manual page 442

14 Problem Solving
Error Code
017-741 [Cause]
[Remedy] Take one of the following measures:
017-742 [Cause]
[Remedy] Check the network connection and the address of the forwarding server.
017-743
[Cause]
[Remedy] Confirm the user ID and the password.
017-744 [Cause]
[Remedy] Confirm the followings:
017-745 [Cause]
[Remedy] Take one of the following measures:
017-746
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
017-747
[Cause]
[Remedy] Wait for a while, and then execute the operation again. If the same message is
017-748
[Cause]
[Remedy] Confirm the network setting of the machine.
017-749 [Cause]
[Remedy] Confirm the job flow settings.
017-750 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
14
017-751
[Cause]
[Remedy] Confirm the detail from [Transmission Report - Job Undelivered].
017-755 [Cause]
[Remedy] Take one of the following measures:
017-759 [Cause]
[Remedy] Contact our Customer Support Center.
442
Cause and Remedy
The job flow cannot be activated.
Install the latest plug-in.
Confirm the job flow settings.
An error occurred while connecting to the forwarding server.
Cannot login to the forwarding server.
An error occurred while connecting to the forwarding server.
You can access to the same path using a computer. There is enough memory capacity
left in the storage destination.
Data could not be sent due to the lack of hard disk memory capacity.
Send with lower resolution.
Send in smaller size.
Send with fewer pages by dividing the job.
Send with [Black & White] set as the [Output Color].
A hard disk error occurred.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
Connection to ApeosWare Authentication Agent to the database timed out because of
an overload.
displayed again, contact our Customer Support Center.
Data could not be sent due to the incorrect machine setting.
An error occurred.
A plug-in error occurred.
on the machine power. If the same message is displayed again, reinstall the plug-in.
A plug-in error occurred.
Cannot download a software.
Confirm that [Enabled] is checked in CentreWare Internet Services under [Properties]
> [Services] > [Machine Software]> [Upgrades].
Download the software through USB connection.
An error occurred during firmware update in the machine.