Turn Signal Flasher - Buell 2003XB9S Service Manual

HOME

TURN SIGNAL FLASHER

REMOVAL
NOTE
The turn signal flasher is not repairable. Replace flasher upon
failure.
1. Remove windscreen. See
2. Remove fastener securing turn signal flasher to front
module.
3. See Figure 7-54. Detach 3-place connector [30] from
flasher body.
INSTALLATION
1. See Figure 7-54. Attach 3-place connector [30] to
flasher.
2. Install turn signal to front module. Tighten fastener to 12-
36 in-lbs (1.4-4.1 Nm).
1 1
WARNING WARNING
Check for proper turn signal operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper turn signal operation could
result in death or serious injury.
3. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to ON.
b. See Figure 7-55.
switch on left handlebar. Front and rear left turn sig-
nals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
4. Install windscreen. See
2.40 FRONT WINDSCREEN.
Activate left turn signals using
2.40 FRONT WINDSCREEN.
8909
Figure 7-54. Turn Signal Flasher
b0586x0x
1
1. Left turn signal
2. Right turn signal
Figure 7-55. Turn Signal Controls
2003 Buell XB9S: Electrical
7.15
2
7-47