Turn Signal Flasher - Buell 2007 FIREBOLT Service Manual

HOME

TURN SIGNAL FLASHER

REMOVAL
NOTE
The turn signal flasher is not repairable. Replace flasher upon
failure.
1. Remove front fairing. See
SHIELD, AND MIRRORS.
2. Remove fastener securing turn signal flasher to head-
light support bracket.
3. Detach 5-place connector [30] from flasher body.
INSTALLATION
1. See Figure 7-55. Attach 5-place connector [30] to
flasher.
2. Install turn signal flasher to headlight support bracket.
Tighten fastener to 36.60 in-lbs (4-6.7 Nm).
3. Install front fairing. See
SHIELD, AND MIRRORS.
1 1
WARNING WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
4. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to IGN.
b. See Figure 7-56.
switch on left handlebar. Front and rear left turn sig-
nals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
7-48 2007 Buell Firebolt: Electrical
2.37 FRONT FAIRING, WIND-
2.37 FRONT FAIRING, WIND-
Activate left turn signals using
8428
Figure 7-55. Turn Signal Flasher
8370
1
1. Left turn signal
2. Right turn signal
Figure 7-56. Turn Signal Controls
7.15
2