Buell 2003XB9S Service Manual page 484

HOME
7. Inspect pulley by spinning wheel (1) and checking for
wheel bearing wear.
8. If pulley wheel needs replacement, remove fastener (6),
washer and nut (2) from idler pulley bracket (4) and dis-
card wheel. Replace with new pulley wheel (1).
NOTE
The pulley wheel bearings can not be replaced separately.
8420
1
1. Axle
2. Pinch bolt fastener
Figure 1-42. Rear Wheel Mounting, Right Side
IDLER PULLEY INSTALLATION
1.
2.
3.
4.
Never tighten rear axle with swingarm brace removed.
5.
2
6.
See Figure 1-43. Install new or existing pulley wheel (1),
if removed, and tighten washer and nut (2) wheel fas-
tener (6) to 20-23 ft-lbs (27.1-31.2 Nm).
Slide idler pulley bracket (4), washer and nuts (5) on to
studs (3) and tighten to 33-35 ft-lbs (45-47 Nm).
Install front sprocket cover. See
COVER.
Install chin fairing fasteners and tighten to 36-48 in-lbs
(4-5 Nm). See 2.34 CHIN
1
CAUTION
See Figure 1-42. Tighten rear axle to 48-52 ft-lbs (65-
70 Nm).
Tighten rear axle pinch fastener (2) to 40-45 ft-lbs (54-
61 Nm).
b1106x6x
1
2
6
1. Wheel
2. Wheel nut
3. Stud
4. Idler pulley bracket
5. Idler pulley bracket nut and washer
6. Wheel fastener
Figure 1-43. Idler Pulley Assembly
2003 Buell XB9S: Drive/Transmission
2.31 SPROCKET
FAIRING.
3
5
4
6-25