Buell 2003XB9S Service Manual page 226

HOME
20. Remove left and right side rider footrests and support
plates. See 2.30 FOOTPEG, HEEL GUARD AND
MOUNT.
NOTE
When removing the right side rider footrest and support plate,
also remove rear brake pedal assembly and remote reservoir
and secure towards rear of vehicle.
1. Upper retaining clamp
2. Clutch cable adjuster boot
3. Lower retaining clamp
Figure 3-20. Clutch Cable Retaining Clamps and
Adjuster Boot
21. See Figure 3-20. Disconnect clutch cable.
a. Remove upper retaining clamp (1) from front isola-
tor.
b. Slide clutch cable adjuster boot (2) up to access
clutch adjuster.
c. Loosen clutch adjuster to release tension from hand
lever.
d. Remove clutch cable ferrule from hand lever.
1
2
3
8720
8712
Figure 3-21. Sidestand Switch with Cable Strap
8712
Figure 3-22. Sidestand Switch
22. See Figure 3-21. Cut cable strap securing sidestand
switch harness.
23. See Figure 3-22. Remove sidestand switch, leaving wire
attached. Pull switch assembly and wire harness through
to right side of vehicle.
24. Remove sidestand assembly.
2003 Buell XB9S: Engine 3-23