Tail Lamp - Buell 2003XB9S Service Manual

HOME

TAIL LAMP

REMOVAL/DISASSEMBLY
1. See Figure 7-45. Remove two screws (2) to detach tail
light lens (4) and tail light (5). If replacing bulb (3), turn
counterclockwise and remove.
2. Remove seat. See 2.41
3. Disconnect three connectors [93] from tail lamp harness
(6).
ASSEMBLY/INSTALLATION
1. See Figure 7-45. Attach the three tail light harness con-
nectors [93] (7).
2. If removed, install tail lamp bulb (3).
a. Turn bulb clockwise to install.
b. Install tail light lens (4) and tail light (5) with two fas-
teners (2).
1 1
WARNING WARNING
Check for proper tail lamp operation before riding motor-
cycle. Visibility is a major concern for motorcyclists. Fail-
ure to have proper tail lamp operation could result in
death or serious injury.
b1139x7x
3
2
1. Center tail section
2. Screws (2)
3. Bulb
4. Lens
5. Tail light
6. Tail light wiring harness
7. Tail light boot
7-42 2003 Buell XB9S: Electrical
SEAT.
4
1
Figure 7-45. Tail Lamp Assembly
3. Check tail lamp for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to ON.
b. Check for tail lamp illumination.
c. Squeeze front brake hand lever. Check for brake
lamp illumination. Release front brake hand lever.
d. Press rear brake pedal. Check for brake lamp illumi-
nation. Release rear brake pedal.
e. Turn ignition key switch to OFF.
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
4. Install seat. See
5
7
1 1
WARNING WARNING
2.41 SEAT.
6
7.12