Buell 2003XB9S Service Manual page 112

HOME
DISASSEMBLY
Bearing Removal
NOTE
On single disc wheels, always remove the brake disc side
first. If the wheel has two brake discs, remove the left bearing
first.
1. See Figure 2-7. Remove wheel bearings using WHEEL
BEARING REMOVER/INSTALLER KIT (Part No. B-
43993-50) and WHEEL BEARING REMOVER AND
INSTALLER (Part No. HD-44060).
2. Sparingly apply EXTREME PRESSURE LUBRICANT
(Part No. J-23444-A) to the threads of the short forcing
screw (1) to prolong service life and ensure smooth oper-
ation.
i04277
4
3
2
1
1. Short forcing screw
2. Nut
3. Nice bearing
4. Washer
5. Bridge
Figure 2-7. Assemble Puller
3. Assemble the short forcing screw (1), nut (2), Nice bear-
ing (3), washer (4) and bridge (5) from the WHEEL
BEARING INSTALLER/REMOVER (Part No.HD-44060).
4. See Figure 2-8. Insert the FRONT WHEEL BEARING
REMOVER COLLET (Part No. B-43993-7, from kit Part
No. B-43993-50) into the wheel bearing until it fully seats
against the bearing.
5
i04276
Figure 2-8. Install Collet and Ball Bearing
5. Insert the ball bearing into the collet.
6. See Figure 2-9. Thread the puller assembly (1) into the
collet (2).
7. Hold the collet (2), and turn the forcing screw (3) to
expand the collet.
i04278
1
1. Puller assembly
2. Collet
3. Forcing screw
Figure 2-9. Expand the Collet
8. See Figure 2-10. Place the bridge (1) against the wheel
hub.
9. Hold the forcing screw (2), and turn the nut (3) clockwise
until the bearing is free of the hub.
2003 Buell XB9S: Chassis
Collet
Ball bearing
3
2
2-9