Buell 2003XB9S Service Manual page 390

HOME
Code 44 Test (Part 1 of 2)
1 Disconnect bank angle sensor
connector [134]. Measure voltage on [134]
between Socket 5 (Lt GY/GN) and
Socket 6 (BK/W). What is voltage?
4.75-5.25 volts
Measure voltage between Socket
4 (R/W) and Socket 6 (BK/W). Is
voltage 4-6 volts?
angle sensor
correctly installed?
Are ferrous metals located within
0.25 in. (6.4 mm) of sides, face or
top of bank angle sensor?
Return to original
configuration.
sensor connected?
YES
YES
Is bank
YES
YES
Is bank angle
11-13 volts
Repair short to
voltage on
Lt GY/GN wire.
7972
Install properly. See
Replace bank angle sensor. See
BANK ANGLE
NO
Reconnect. Clear
codes and cycle
ignition key.
Recheck for codes.
7971
0 volts
STOP
Go to Code 44 Test
(Part 2 of 2).
NO
Repair open in
R/W wire between
[134] and
harness.
7975
NO
4.34 BANK
ANGLE SENSOR.
NO
4.34
SENSOR.
7976
2003 Buell XB9S: Fuel System 4-81