Buell 2003XB9S Service Manual page 169

HOME
DISASSEMBLY
1. See Figure 2-93. Remove rubber boots (1) from rear of
headlight housing.
2. Disconnect wiring harness (5) from headlight bulbs (3)
and remove along with position bulb socket (6).
3. Remove bulb holders (2).
4. Remove headlight bulbs (3) from back of headlight hous-
ing (4).
1. Boot (2), headlight
2. Bulb holder (2)
3. Bulb (2)
4. Headlight housing
5. Wiring harness
6. Position bulb socket,
(used for HDI only)
b1150x2x
5
2-66 2003 Buell XB9S: Chassis
1
2
6
Figure 2-93. Headlight Assembly
ASSEMBLY
1. See Figure 2-93. Align and install headlight bulbs (3) into
back of headlight housing (4).
The tab on the base of the headlight bulb should rest
between the two tabs located at the top of the hole on the
back of the headlight assembly.
2. Install bulb holders (2).
3. Connect wiring harness (5) to headlight bulbs (3) and
install rubber boots (1) and install position bulb socket (6)
between the headlights.
3
4
NOTE
b1147x2x