Buell 2003XB9S Service Manual page 581

HOME
8905a
1. Turn signal flasher connector [30]
2. Instrument cluster connector [39]
3. Right handlebar connector [22]
4. Left handlebar connector [24]
5. Turn signal connectors [31]
13. Remove windscreen. See
14. See Figure 7-79. Disconnect:
Turn signal flasher connector [30].
Instrument module connector [39].
Left switch housing connector [24] and right switch
housing connector [22].
Turn signal connectors [31].
Headlight connector [38].
Horn connectors [122].
Clutch switch [95] from left switch housing.
Front brake switch [121] from right switch housing.
15. Cut and remove cable strap (6) securing main harness to
ignition switch.
16. Disconnect wiring located under sprocket cover. See
7.25 SPROCKET COVER
17. Remove heat shrink tubing and disconnect sidestand
switch [133] (1). See 7.5 STARTER
18. Remove connector from oil pressure switch [120]. Oil
pressure switch is located on front of engine. See
OIL PRESSURE INDICATOR
7-66 2003 Buell XB9S: Electrical
1
5
9
Figure 7-79. Electrical Connectors Behind Windscreen
2.40 FRONT WINDSCREEN.
WIRING.
INTERLOCK.
3.10
SWITCH.
2
3
6
7
6. Cable strap
7. Main harness
8. Headlight connector [38]
9. Horn connectors [122]
19. Disconnect intake air temperature sensor [89]. See
INTAKE AIR TEMPERATURE
20. Disconnect throttle position sensor [88]. See
THROTTLE POSITION
21. Disconnect fuel line at fuel rail.
22. Remove spark plug wires.
23. Remove any remaining cable straps and clamps secur-
ing wire harness and remove harness from front of vehi-
cle.
24. Pull the main harness out through the rear of the frame/
fuel tank assembly between the trunk pan and the rear
tire.
NOTE
Using scissors jack, raise vehicle higher to gain more clear-
ance between the trunk pan and tire.
25. Remove all push pins.
4
5
8
SENSOR.
SENSOR.
4.35
4.36