Turn Signal Flasher - Buell X1 2002 Service Manual

HOME

TURN SIGNAL FLASHER

REMOVAL
NOTE
The turn signal flasher is not repairable. Replace flasher
upon failure.
1. Remove seat. See 2.40 SEAT.
1. See Figure 7-46. Remove nut, ECM mounting bolt and
flasher from under seat.
2. Detach 3-place connector [30] from flasher body.
INSTALLATION
1. See Figure 7-46. Attach 3-place connector [30] to
flasher.
2. Install right ECM mounting bolt and nut to install flasher.
1 1
WARNING WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
3. Install seat. See 2.40 SEAT.
1 1
WARNING WARNING
Check for proper turn signal operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper turn signal operation could
result in death or serious injury.
4. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to IGN.
b. See Figure 7-47.
switch on left handlebar. Front and rear left turn sig-
nals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
7-36
Activate left turn signals using
8296
Connector [30]
Figure 7-46. Turn Signal Flasher
6981
1
1. Left Turn Signal
2. Right Turn Signal
Figure 7-47. Turn Signal Controls
7.14
Flasher
2
2002 Buell X1: Electrical