Buell 2003XB9S Service Manual page 526

HOME
INSPECTION
1. Inspect spark plug cables. Replace cables that are worn
or damaged.
a. Check for cracks or loose terminals.
b. Check for loose fit on ignition coil and spark plugs.
2. Check cable boots/caps for cracks or tears. Replace
boots/caps that are worn or damaged.
NOTE
Both cables are the same length.
3. See Figure 7-9. Check spark plug cable resistance with
an ohmmeter. Replace cables not meeting resistance
specifications.
Table 7-10. Spark Plug Cables
SPECIFICATION
Length-in. (mm)
Resistance - ohms
INSTALLATION
NOTES
To ease installation, install spark plug cables to ignition
coil first.
See 1.14 SPARK PLUGS
1. Connect spark plug cables to ignition coil and spark
plugs. Fasten boots/caps securely. Tight connections
provide the necessary moisture-proof environment for
the ignition coil and spark plug terminals.
2. Install airbox assembly. See
FRONT & REAR
5.75
(146)
1,430-3,360
for spark plug information.
4.43 AIRBOX.
7117
1
3
1. Ohmmeter positive lead
2. Ohmmeter negative lead
3. Spark plug cable (typical)
4. Ohmmeter
Figure 7-9. Testing Resistance
2003 Buell XB9S: Electrical
4
2
7-11