Buell 2003XB9S Service Manual page 221

HOME
8707
1. Fuel line connection
2. Connection for throttle position sensor [88]
CAUTION
Remove shop towel from entrance of throttle body to
ensure proper operation of induction module.
18. See Figure 3-15. Connect throttle position sensor (2)
[88].
19. Connect fuel injector leads (3) [84 & 85].
20. Connect fuel line.
21. Install throttle body velocity stack (tighten).
22. Install airbox assembly and intake cover and tighten fas-
teners to 84-120 in-lbs (9.5-13.6 Nm).
23. Install rear belt and idler pulley. See
and 2.13 REAR BRAKE MASTER CYLINDER.
24. Install left side rider footrest and support plate and
tighten fasteners to 120-144 in lbs (13.56-16.27 Nm).
25. Install sprocket cover and tighten fasteners and washers
to 12-36 in-lbs (1-4 Nm).
26. Install chin fairing. See 2.34 CHIN FAIRING.
27. Install air scoops, right and left sides. See
SCOOPS.
3-18 2003 Buell XB9S: Engine
Figure 3-15. Fuel Line and DDFI Electrical Connections
1.10 DRIVE BELT
2.36 AIR
2
1
3
3. Connections for fuel injectors [84 & 85]
28. Connect fuel pump.
NOTE
The connection for fuel pump is just above the pump located
at the rear of the fuel tank on the left side of the vehicle.
11 1
WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion which could result in death or serious injury.
29. Connect negative ground cable to battery and install seat
(tighten).
11 1
WARNING
Pull up on seat to verify that it is properly secured, front
and rear. A loose seat may shift during vehicle operation
and startle the rider, possibly causing loss of vehicle
control resulting in death or serious injury.
WARNING
WARNING