Buell 2003XB9S Service Manual page 218

HOME
8720
Figure 3-11. Clutch Cable Retaining Clamp
8768
1. Verify that the clutch cable and feed line have a clearance of 1/8-1/4 in. (3.175-6.35 mm) between them.
2. Verify that oil lines have a minimum clearance of 1/8 in. (3.175 mm) between them.
Figure 3-12. Oil Cooler Feed and Return Oil Line Orientation and Clearances
1
10. See Figure 3-11. Pull clutch cable back up into the
proper position.
a. Connect clutch cable to handlebars and adjust to
specifications. See
b. Install retaining clamp.
NOTE
When torquing the feed oil line from the pump to the oil cooler
it is necessary to torque the fitting at the oil pump first.
11. See Figure 3-12. Install oil cooler oil feed line first and
tighten to 15-17 ft-lbs (20.3-23 Nm).
NOTE
When installing the oil cooler return oil line it is necessary to
install the end at the crankcase first.
12. See Figure 3-12. Install the oil cooler return oil line and
tighten to 15-17 ft-lbs (20.3-23 Nm).
2
2003 Buell XB9S: Engine
3.1 SPECIFICATIONS.
3-15