Buell 2003XB9S Service Manual page 473

HOME
7
8
9
1. Retaining ring
2. Spring seat
3. Diaphragm Spring
4. Retaining ring
5. Release plate
6. Retaining ring
7. Bearing
8. Adjusting screw
9. Pressure plate
Figure 6-20. Adjusting Screw Assembly
10. See Figure 6-20. Remove and disassemble adjusting
screw assembly.
a. Remove large retaining ring.
b. Remove adjusting screw assembly from pressure
plate.
c. If necessary, disassemble adjusting screw assem-
bly. Remove and discard small retaining ring (6) and
then separate the adjusting screw (8) from the bear-
ing (7) and release plate (5). Remove bearing (7)
from release plate (5).
6-14 2003 Buell XB9S: Drive/Transmission
b1062x6x
5
6
3
4
2
1
11. Remove clutch hub from clutch shell for inspection.
NOTE
See Figure 6-21. The clutch shell incorporates a compensat-
ing spring set and new style needle bearing.
8802
Figure 6-21. Compensating Spring Set