Buell 2003XB9S Service Manual page 89

HOME
INSTALLATION
1. See Figure 1-38. Place filter element (1) on baseplate
(2).
2. See Figure 1-37. Position airbox cover (1) over base-
plate. Make sure air filter remains correctly positioned.
3. Install airbox cover by latching six latch tabs (4) to base-
plate.
4. Position fuel vent tube (2) in groove on top of airbox and
connect to fuel vent valve (3). Secure vent tube to vent
valve with new cable strap.
5. Install intake cover assembly with four fasteners and
nylon washers. Tighten fasteners to 12-36 in-lbs (1-
4 Nm).
1 1
WARNING WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
6. Install seat. See 2.41 SEAT.
8373
1
2
1. Breather hoses (2)
2. Intake air sensor
3. Velocity stack
Figure 1-39. Airbox Baseplate Assembly
2003 Buell XB9S: Maintenance
3
1-39