Buell 2003XB9S Service Manual page 564

HOME
INSTALLATION
Right Side
1. Attach throttle cables to hand control. See
TLE CONTROL.
2. Install right switch housing.
a. Position housing on right handlebar by engaging
alignment pin on front housing with hole in handle-
bar.
b. Attach switch housing with two mounting fasteners
and tighten to 25-33 in-lbs (3-4 Nm).
3. Attach brake switch connector [121].
4. Attach right handlebar switch connector [22] to wire har-
ness. See D.1 HOSE AND WIRE ROUTING
ing information.
1 1
WARNING WARNING
Check all handlebar switch operations before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Handlebar switches not operating properly could
result in death or serious injury.
5. Check handlebar switch for proper operation. If operation
fails, reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to ON.
b. Set ENGINE STOP SWITCH to RUN.
c. Start motorcycle.
d. Turn ignition key switch to OFF.
6. Turn ignition key switch to OFF.
2.23 THROT-
for wire rout-
Figure 7-58. Right Handlebar Switch Connection
Right Handlebar Switch
[22A]
To Ign. relay
GY
4
From Ign. relay
W/BK
3
From Ign. relay
W/BK
2
To starter relay
BK/R
1
Accessory power O
1
To stoplight
R/Y
2
[121A]
Brake Switch
2003 Buell XB9S: Electrical
[22B]
GY/O
W/BK
W/BK
BK/R
O
R/Y
[121B]
7-49