Turn Signal Flasher; Removal - Buell XB 2008 Series Service Manual

TURN SIGNAL FLASHER

REMOVAL

The turn signal flasher is not repairable. Replace flasher upon
failure.
1. Remove front fairing or windshield/windscreen. See
2.49 FRONT FAIRING, WINDSHIELD, AND MIRRORS:
FIREBOLT (Firebolt) or
SCREEN: LIGHTNING AND ULYSSES
Ulysses).
2. See Figure 7-41 (Firebolt),
Figure 7-43 (Ulysses). Remove fastener securing turn
signal flasher to headlight support bracket (Firebolt) or
front module (Lightning and Ulysses).
3. Detach 5-place connector [30] from flasher body.
INSTALLATION
1. See Figure 7-41 (Firebolt),
Figure 7-43 (Ulysses). Attach 5-place connector [30] to
flasher.
2. Install turn signal flasher to headlight support bracket
(Firebolt) or front module (Lightning and Ulysses).Tighten
fastener to 36-60 in-lbs (4-6.7 Nm).
3. Install front fairing or windshield/windscreen. See
2.49 FRONT FAIRING, WINDSHIELD, AND MIRRORS:
FIREBOLT (Firebolt) or
SCREEN: LIGHTNING AND ULYSSES
Ulysses).
Be sure that all lights and switches operate properly before
operating motorcycle. Low visibility of rider can result in
death or serious injury. (00316a)
4. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were performed.
a. Turn ignition key switch to IGN.
b. See Figure 7-44. Activate left turn signals using switch
on left handlebar. Front and rear left turn signals must
flash.
c. Activate right turn signals using switch on left
handlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
7-30 2008 XB Service: Electrical
NOTE
2.50 WINDSHIELD AND WIND-
(Lightning and
Figure 7-42 (Lightning) or
Figure 7-42 (Lightning) or
2.50 WINDSHIELD AND WIND-
(Lightning and
sm00406
Figure 7-41. Turn Signal Flasher: Firebolt (Typical)
sm00460
Figure 7-42. Turn Signal Flasher: Lightning
sm00459
Figure 7-43. Turn Signal Flasher: Ulysses
7.11