Turn Signal Flasher - Buell 2007 ULYSSES Service Manual

HOME

TURN SIGNAL FLASHER

REMOVAL
NOTE
The turn signal flasher is not repairable. Replace flasher upon
failure.
1. Remove windshield and windscreen. See 2.44 WIND-
SHIELD AND WINDSCREEN.
2. Remove fastener securing turn signal flasher to front
module.
3. See Figure 7-59. Detach 5-place connector [30] from
flasher body.
INSTALLATION
1. See Figure 7-59. Attach 5-place connector [30] to
flasher.
2. Install turn signal to front module. Apply LOCTITE 271
(red) and tighten fastener to 48-72 in-lbs (5.4-8.1 Nm).
1 1
WARNING WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
3. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to ON.
b. See Figure 7-60.
switch on left handlebar. Front and rear left turn sig-
nals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
4. Install windscreen and windshield. See
SHIELD AND WINDSCREEN.
Activate left turn signals using
2.44 WIND-
11930b
Figure 7-59. Turn Signal Flasher
b0586x0x
1
1. Left turn signal
2. Right turn signal
Figure 7-60. Turn Signal Controls
2007 Buell Ulysses: Electrical
7.16
2
7-53