Buell 2003XB9S Service Manual page 583

HOME
8905a
1. Turn signal flasher connector [30]
2. Instrument cluster connector [39]
3. Right handlebar connector [22]
4. Left handlebar connector [24]
5. Turn signal connectors [31]
7. See Figure 7-82. Connect:
Front brake switch [121] from right switch housing.
Clutch switch [95] from left switch housing.
Horn connectors [122].
Headlight connector. [38].
Turn signal connectors [31].
Left switch housing connector [24] and right switch
housing connector [22].
Instrument module connector [39].
Turn signal flasher connector [30].
8. Install cable strap (6) loosely around main harness (6)
and ignition switch.
9. Connect throttle position sensor [88]. See
TLE POSITION SENSOR.
10. Connect intake air temperature sensor [89]. See
INTAKE AIR TEMPERATURE
11. Install spark plug wires.
12. Install connector on oil pressure switch [120]. See
OIL PRESSURE INDICATOR
13. Install sprocket cover wiring. See
COVER WIRING.
14. Connect sidestand switch connector [133]. Install heat
shrink tubing. Install cable strap securing sidestand
switch wiring to sidestand switch bracket. See
STARTER INTERLOCK.
7-68 2003 Buell XB9S: Electrical
1
5
9
Figure 7-82. Electrical Connectors Behind Windscreen
4.36 THROT-
4.35
SENSOR.
3.10
SWITCH.
7.25 SPROCKET
7.5
2
3
6
7
6. Cable strap
7. Main harness
8. Headlight connector [38]
9. Horn connectors [122]
15. Connect fan connector [97].
16. Install fan and tighten fasteners to 12-36 in-lbs (1.4-4.1
Nm). See 4.37 COOLING
17. Install rear shock absorber assembly. See
SHOCK ABSORBER.
18. Pull rear section of main harness up over trunk pan
towards the rear of the vehicle and place connectors in
general location of installation.
19. Install fuse block and relay center on support bracket.
20. See Figure 7-82. Connect:
Ground terminals on right side tail section [GRD 1] &
[GRD 3].
Tail light connectors [93].
Left turn signal connector [19].
Right turn signal connector [18].
BAS (bank angle sensor) connector [134].
ECM connectors [10, 11].
Rear brake light switch connector [121].
Wire harness ground [GRD 2].
21. Install starter side of positive battery cable to starter.
4
5
8
FAN.
2.22 REAR