Buell 2003XB9S Service Manual page 216

HOME
18. Support engine with wide scissors jack.
19. See Figure 3-6. Remove front "V" bracket with oil cooler
from main frame:
a. Remove cable strap securing the remote idle adjust-
ment cable.
b. Remove the three cable straps holding regulator wir-
ing harness in order to extend the harness to
remove "V" bracket.
c. Unplug regulator harness, (2 plugs).
d. Remove front tie bar from "V" bracket only.
e. Unbolt "V" bracket from main frame and remove
from left side.
20. Remove center tie-bar from engine.
1
1. Rear isolator bolt
2. Rear tie bar
Figure 3-7. Rear Isolator Bolt and Rear Tie Bar
21. See Figure 3-7. Remove rear tie bar from frame only.
22. Loosen rear isolator bolt. DO NOT REMOVE.
2
2
1. Front isolator bolt
2. Front isolator mount
3. Front tie bar
Figure 3-8. Front Isolator and Tie Bar Assemblies
23. See Figure 3-8. Remove front isolator bolt (1).
24. Remove front isolator mount (2) from engine.
25. Rotate engine down.
2003 Buell XB9S: Engine
1
3
3-13