Buell 2003XB9S Service Manual page 408

HOME
INSTALLATION
CAUTION
Do not pull on engine temperature sensor wiring. Excess
strain to sensor wiring will cause sensor damage.
1. See Figure 4-76. Screw sensor into rear cylinder head.
NOTE
In next step, make sure wire is in cutout portion (slot) of
socket to prevent damage.
2. Secure sensor with Snap-on socket M3503B. Tighten ET
sensor to 120-168 in-lbs (13.6-19 Nm).
NOTE
Orient the rubber boot so the flat on the boot is towards the
left side of the motorcycle.
3. Push rubber boot down sensor wire towards cylinder
head until it seats in hole on top of ET sensor.
4. See Figure 4-77. Connect ET sensor 1-place connector
[90] to wiring harness.
5. Install right upper tie bar fastener (2). Tighten fastener to
25-27 ft-lbs (33.9-36.6 Nm).
6. Install airbox. See 4.43
7. Install intake cover assembly. See
ASSEMBLY.
8. Connect negative battery cable.
AIRBOX.
2.35 INTAKE COVER
2003 Buell XB9S: Fuel System 4-99