Buell 2003XB9S Service Manual page 447

HOME
STARTER
REMOVAL
1. Remove seat. See 2.41
1 1
WARNING WARNING
Always disconnect the negative battery cable first. If the
positive cable should contact ground with the negative
cable installed, the resulting sparks may cause a battery
explosion which could result in death or serious injury.
2. Disconnect battery. See
3. Remove primary cover. See
6.2 PRIMARY CHAIN.
4. Remove sprocket cover. See
NOTE
A ball hex driver may be required to gain access to the starter
mounting bolts.
5. See Figure 5-8. Remove two starter mounting bolts and
washers (1).
6. See Figure 5-9. Remove fastener with washer (1) (met-
ric).
a. Remove protective boot.
b. Remove positive battery cable ring terminal (2).
c. Detach solenoid wire (3).
7. Remove starter and gasket from the gearcase cover side.
5-12 2003 Buell XB9S: Starter
SEAT.
1.5 BATTERY MAINTENANCE.
PRIMARY COVER under
2.31 SPROCKET COVER.
1. Mounting bolts and washers
2. Starter
Figure 5-8. Starter Mounting
8742
1
1. Fastener with washer (metric)
2. Positive battery cable ring terminal
3. Solenoid wire
Figure 5-9. Starter Wires (Protective Boot Not Shown)
5.7
b0312x5x
1 2
1
3
2