Power Trim Pump - FNM HPEP 225 Installation Manual

Power Trim Pump

IMPORTANT: Check oil level with sterndrive unit in the full DOWN / IN position.
IMPORTANT: Use Quicksilver Power Trim and Steering Fluid, or SAE 10W-30 or
10W-40 engine oil in trim system.
1. Unscrew fill cap and remove and discard cap plug from fill neck. Replace fill cap.
2. Fully raise and completely lower drive unit 6 to 10 times to purge air from system.
3. Position drive unit in the full DOWN / IN position. Check oil level visually. Oil level should
4. Check all trim line connection points for leaks. If fluid is visible at fittings, torque fitting.
a - Cap Plug
b - Fill Cap
be maintained at bottom lip of fill neck.
a - Fill Neck
Torque fittings to 125 Ib-in. (14 Nm).
87