Exhaust System - FNM HPEP 225 Installation Manual

Exhaust System

IMPORTANT: It is the responsibility of the boat manufacturer or installing dealer to
properly locate the engine and install the exhaust system. Improper installation may
allow water to enter the exhaust manifolds and combustion chambers and severely
damage the engine. Damage caused by water in the engine will not be covered by
C.M.D. srl Warranty, unless this damage is the result of defective part(s).
Verify that the riser provides the required dimension "c," or a distance greater than "c," as
indicated.
HPEP 225 - 250
Model
Engine With Standard Riser
a - From Waterline To Top Of Transom
b - From Highest Point On Exhaust Riser To Top Of Transom
c - From "a" Minus "b"
d - Waterline At Rest
"c" = "a" Minus "b"
"c" Must Be 280 mm (11 inches) or More
15