Sterndrive Installation - FNM HPEP 225 Installation Manual

Sterndrive Installation

1. Remove trim cylinders support and dust cover from bell housing studs. (Retain locknuts
and flat washers.)
2. Remove gear lube monitor bottle cap. Fill with gear lubricant.
3. Push dribble valve stern drive in until gear lube appears. Release dribble valve.
4. Fill monitor to FILL mark and replace monitor cap.
5. Coat entire stud and threads with 2-4-C Marine Lubricant with Teflon.
a – Typical gear lube monitor bottle
b -Cap
a – Dribble Valve Stern
a - Studs (6)
b
80