FNM HPEP 225 Installation Manual page 116

FNM-HPEP 225/250
20. Eyelet connector for fuel pump
These are two eyelet connectors that are supposed to feed the fuel pump.
The feeding is protected by a fuse.
The red eyelet connector is to be connected to the positive of the fuel pump (+ sign on the
•
pump); in order to secure and fasten this connector, you need to use a wrench N° 7;
The black eyelet connector is to be connected to the negative of the fuel pump (- sign on the
•
pump); in order to secure and fasten this connector, you need to use a wrench N° 8;
21. Connector for the VDO temperature sensor
These are connectors that the temperature signal from the VDO sensor placed on the engine and then
send this signal to the panel instrument.
22. Connector for the VDO pressure sensor
This is a connector that takes the pressure signal from the VDO sensor placed on the engine and then
send it to the panel instrument. The eyelet connector stands for the ground signal.