FNM HPEP 225 Installation Manual page 71

INSTRUMENT AND EXTENSION HARNESS
1. Connect instrument extension harness to instrument harness ends. Connector collars
IMPORTANT: When routine any wiring extension harness back to the engine, make
sure that the harness does not rub or get pinched.
2. Route instrument extension harness back to the engine. Fasten harness to the boat at
3. Connect extension harness to engine harness end. Connector collars must be fully
NOTE: If using other than CMD instrumentation and harnesses, refer to manufacturers'
instructions.
a
Connections
a – Instrument Extension Harness
b – Engine Harness
c – Connector Collar "bayonet"
TRIM POSITION SENDER CONNECTION
Connect trim position sender leads from gimbal housing to leads from engine harness.
Trim Position Sender Leads
must be fully engaged and secure. Tighten threaded connector collar of extension
harness onto instrument harness connector.
least every 400 mm (17 in.) using appropriate fasteners.
engaged and secure. Tighten threaded connector of extension harness onto engine
connector.
a –From Engine Harness
b – From Gimbal Housing
71
b
c