FNM HPEP 225 Installation Manual page 74

4. Install drive unit shift cable. Tighten locknut until it contacts end guide, then
loosen 1/2 turn. Insert cotter pin from the top and spread both ends.
a - Washers (2)
b -Locknut
c - Cotter Pin
5. Place adjustment tool over drive unit shift cable. Hold tool in place, using a piece of tape
over the barrel retainer.
a. Shift remote control to NEUTRAL.
b. Push in on shift cable end with enough pressure to remove play, and mark position
"a" on tube.
c. Pull out on shift cable end with enough pressure to remove play, and mark position
"b" on tube.
d. Measure distance between marks "a" and "b" and mark position "c" half-way be
tween marks "a" and "b."
IMPORTANT: Be sure to keep center mark "c" aligned with remote control shift cable
end guide edge when making the following adjustment.
74