FNM HPEP 225 Installation Manual page 56

Engine Preparations
1. Remove and read all tags attached to the engine.
2. Remove all hardware that secures engine to shipping container.
3. Connect battery cables to engine. Be sure to observe the following:
a. Make sure that grounding stud and starter solenoid terminal are free of paint or
b. Ensure the positive battery cable is inserted through the protective rubber boot
c. After battery cables are connected, apply a thin coat of liquid neoprene to the
d. Be sure to slide rubber boot over positive (+) terminal after making connection.
a
b
4. Drape battery cables over top of engine to prevent them from getting in the way during
installation.
any other material that could cause a poor electrical connection.
before attachment.
terminals.
a – Engine Starter
b – Positive (+) Battery Cable Location
c – Negative (-) Battery Cable Location
56
c