FNM-HPE200
Installing Steering System
MANUAL STEERING
1. Inspect bushings for debris. Rubricate bushings with Special Lubricant 101.
Manual Steering
2. Remove shipping hardware.
3. Remove upper and lower pivot bolts and ensure threads are well lubricated with Special
Refer to Installation Requirements – Steering Helm and Cable for steering selection
and couplet nut locking requirements.
4. Install steering assembly as follows:
a - Bushings
b – Special Lubricant 101
Lubricant 101.
a. Position steering assembly so that pivot bolts will enter bushings in pivot block or
power steering control valve.
b. Install upper and lower pivot bolts along with tab washers. Ensure tab washer
tangs straddle the ridge on inner transom plate.
c. Turn pivot bolts all the way in by hand to censure proper alignment.
d. Ensure steering assembly pivots freely.
Notice to Installer
43