Connecting Gear Lube Monitor Hose And Installing Water Inlet Fitting - FNM HPEP 225 Installation Manual

FNM-HPE200

Connecting Gear Lube Monitor Hose And Installing Water Inlet Fitting

1. Connect the gear lube monitor hose to quick release 90° fitting. Secure with hose clamp.
2. Connect fitting to the gimbal housing.
3. Install water inlet fitting. Install hose clip. Torque bolts and star washers to 5 Nm (45 lb-
4. Route lube monitor hose to port side of engine. Secure with hose clip.
IMPORTANT: Hose must not come in contact with steering system components, the
engine couplet, U-joint shaft or drive shaft.
a – Hose
b – 90° Hose Fitting
c – Hose Clamp
d – Gimbal Housing Fitting
e – Gear Lube Monitor
in.).
a – Gear Lubee Monitor Hose
b – Hose Clamp
c – Clamp
d – Water Inlet Fitting
e – Bolts and Star Washers
51