Trim Position Sender Adjustment
1. Loosen both trim position sender retaining screws.
2. Turn ignition key to the RUN position.
3. Trim drive unit to the full DOWN / IN position.
4. Rotate trim position sender, as required, to show full DOWN / IN position on dashboard
5. Tighten retaining screws and turn ignition key to the OFF position.
a - Retaining Screws (2)
b - Trim Position Sender
DO NOT start engine in the following step or damage to drive unit and engine
could result from lack of cooling water.
instrument as shown.
a - Trim Gauge Needle
b - Full DOWN / IN Position
a - Retaining Screws (2)
b - Trim Position Sender
CAUTION
88