FNM HPEP 225 Installation Manual page 49

8. Connect steering cable as follows:
a. Remove shipping cap from both ends of steering cable guide tube.
b. Coat steering cable end with a liberal amount of Special Lubricant 101.
c. Install steering cable and secure with hardware as shown.
Refer to "Installation Requirements – Steering Helm and Cable" for steering cable selection and
coupler nut locking requirements.
d. Using a suitable wrench hold the flat surfaces on the cable guide tube in the vertical
IMPORTANT: Slight feedback in the steering system could be encountered if the
cable guide tube flat surfaces are not positioned vertically.
a – Steering Cable
b – Grease Fitting
c – Cable Couplet Nut
d – Cable Guide Nut
e – Steering Cable End
f - Clevis
g –Clevis Pin
h – Cotter Pin
Steering cable outer casing must be free to move back and forth for steering system to
NOTICE TO INSTALLER
position. Torque coupler nut to 47 Nm (35 lb-ft). Be certain the flat surfaces are
still aligned vertically after torque is applied to coupler nut.
CAUTION
function properly. Do not fasten any items to steering cable.
49