FNM HPEP 225 Installation Manual page 84

IMPORTANT: On Bravo One. Two and Three Models, the Trim-In Limit Insert must be
properly positioned before installing the trim cylinder anchor pin in the following
steps.
15. Ensure that the Trim-In Limit Insert is positioned as shown for the appropriate Bravo
model.
Bravo One and Two
(Positioned Forward)
a - Trim-In Limit Insert
IMPORTANT: The position of the Trim-In Limit Insert on the Bravo Three sterndrive
unit should only be changed after the boat has been properly tested. Refer to
statement at the front of this manual entitled "Bravo Three Notice: Trim In Limit
Insert."
IMPORTANT: To aid in installing bushings, use a water and soap solution. DO NOT
use oil or grease.
16. Install trim cylinders on aft end of drive unit with hardware as shown. Coat anchor pin
threads with 2-4-C Marine Lubricant with Teflon and tighten nuts until they contact.
Install plastic caps and tighten hand tight only.
a - Aft Anchor Pin
b - Large I.D. Flat Washers (2)
c - Bushings (4)
d - Small I.D. Flat Washers (2)
e - Locknuts (2)
f - Plastic Caps (2)
17. Place drive unit serial number decal as described in General Information.
Bravo Three
(Positioned Aft)
84