FNM HPEP 225 Installation Manual page 31

ATTENTION: If using a steering cable that does not have a self-locking coupler nut,
an external locking device must be used.
a - Steering Cable
b - Grease Fitting
c -Cotter Pin
d - Locking Sleeve (If Required - Must Be Ordered Separately)
e - Cable Coupler Nut
f - Cable Guide Tube
POWER STEERING UNITS ONLY - If steering cable with improper dimensions is
installed, severe damage to transom assembly and/or steering system may result. DO
NOT attempt to adjust cable guide tube on power steering unit, as guide tube and
locknut have been torqued (with Loctite) at the factory, and an attempt to loosen nut or
tube may result in damage to tube.
1. Steering cable must be the correct length, particularly when installed in larger boats.
2. Avoid sharp bends, kinks or loops in cable.
3. Power Steering fully extended steering cable end dimension must be as shown on the
following page.
CAUTION
31