FNM HPEP 225 Installation Manual page 82

11. Pull out shift linkage as far as it moves. "Jaws" will open, as shown.
IMPORTANT: As sterndrive is inserted into drive unit, entry of the bell housing shift
cable must be closely checked to make sure cable enters the jaws of shift linkage
assembly in the sterndrive.
12. Place remote control in neutral position.
NOTE: As bell housing shift cable enters the shift linkage assembly, it pushes the assembly
back into the sterndrive housing, and the jaw closes, securing the cable, as shown in "A,"
"B,"and"C."
IMPORTANT: If Bell Housing Shift Cable does not line up to properly enter jaws of shift linkage
assembly, cable will have to be aligned manually.
a - Shift Linkage
Assembly
b - Bell Housing
Shift Cable
a - Shift Linkage
(b)
A
B
C
7
82