5. Torque pivot bolts to 34 Nm (25 Ib-ft). Bend washer tabs against corresponding flats on
NOTE: It may be necessary to tighten further to align flats on pivot bolt with tabs on tab
kasher.
MOVING THE CONTROL VALVE CABLE GUIDE TUBE with the hoses disconnected will expel fluid from
the ports. Wear eye protection.
6. The cable guide tube may be stiff and difficult to move when you attempt to pull it out
bolt heads.
a – Tab Washer
b –Ridge
c – Pivot Bolts
or push it in for installation. First move the cable tube in the directions shown below.
a - Ports
b – Control Valve Cable Guide Tube
CAUTION
47