FNM HPEP 225 Installation Manual page 75

6. Adjust remote control shift cable as follows:
7. Install remote control shift cable. Tighten locknut until it contacts cable end guide. Insert
a -Locknut
b - Washers - Both Sides of Barrel
c -AnchorPin
d - Cotter Pin (Not Visible)
8. Remove adjustment tool.
a. Temporarily install shift cable end guide into shift lever and insert anchor pin.
b. Adjust shift cable barrel so that hole in barrel centers with vertical centerline of stud.
Ensure that backlash center mark is aligned with edge of control cable end guide.
DO NOT attempt to install or remove remote control shift cable barrel from stud,
without first removing end guide anchor pin from shift lever, and removing cable.
Attempting to bend shift cable to install or remove barrel, will place undue stress
on cable end guide and shift lever, and damage to both could occur.
c. Remove shift cable end guide from shift lever by removing anchor pin.
a - Remote Control Shift Cable End Guide
b - Anchor Pin
c - Backlash Center
d - Remote Control Shift Cable Barrel
e -Stud
cotter pin from the top and spread both ends.
CAUTION
75