FNM HPEP 225 Installation Manual page 72

NEUTRAL SAFETY SWITCH
1. Connect neutral safety switch wires at instrument panel and remote control. Refer to
MERCATHODE CONTROLLER (IF EQUIPPED)
1. Connect electrical leads to controller assembly.
2. Apply a thin coat of liquid neoprene to ALL electrical connections.
IMPORTANT: Ensure that opposite end of Red/Purple wire is connected to the
positive (+) battery terminal.
appropriate wiring diagram. Secure connections. If using bolt and nut, coat with liquid
neoprene. Slide rubber sleeve over connections.
Neutral Safety Switch Wiring With Bullet Connectors
Neutral Safety Switch Wiring Using Bolt and Nut
a – From Remote Control
b – From Instrument Harness
c – Rubber Sleeve
TYPICAL
a – ORANGE Wire – From Electrode on Transom Assembly
b – RED/PURPLE Wire – Connect (Other End) to Positive (+) Battery Terminal
c – BLACK Wire – From Engine Harness
d – BROWN Wire – From Electrode on Transom Assembly
72