FNM HPEP 225 Installation Manual page 96

b. Turn steering wheel RIGHT until it stops, and continue to apply pressure. If pump
lugs (engine rpm drops and/or power steering pump tone changes), check the fol-
lowing:
(1.) Inspect for an obstruction between gimbal ring and gimbal housing and all mov-
ing steering components.
(2.) Ensure that steering lever is not contacting cutout in transom. If contact is being
made, modify cutout.
(3.) Check steering cable end dimension with cable FULLY EXTENDED. Refer to
Installation Requirements for proper steering cable dimensions.
14. Stop the engine and turn the key switch OFF.
15. Lubricate steering cable and clevis with Special Lubricant 101.
IMPORTANT: Make sure the cable end that enters clevis is heavily lubricated with
Special Lubricant 101.
a - Steering Cable End
b -Clevis
c - Clevis Pins and Cotter Pins
d - Steering Lever
96